GREASES & PASTES - INDUSTRY
GREASES & PASTES are available with an extreme long-term lubrication protection upon request.
Lubricants shall be a place of lube oils, if economic or technical reasons, their use is beneficial or lubricants can not be used. This is for example the case when drain the oil would flow out and or the (permanent) oil supply would not be possible or too costly.
Just need lubrication points which are not sufficiently protected against the ingress of dirt and water, are lubricated with grease, because the fat has a sealing collar. Moreover, cement is grease trap bearing loads better and have in the mixed and boundary friction better lubricating properties than oil. In most cases, it is not replaced or refilled, then it constitutes a lifetime lubrication. Lubricants are used on gears, taping, hinges, steering systems, various bearings, sliding surfaces and brake valves.
Basically, the following requirements are met:
Greases must remain at low temperatures soft, supple and eligible. At high temperatures drop they are not allowed. They also have hot water (in cooling water pumps) and compatible with paint (on hinges) and dichtungsverträglich (not brittle, shrink or soften his). Since often a lifelong permanent filling is assumed to be extremely lubricants to aging.
( GREASES & PASTES include only products for the industrial sector. Other GREASES & PASTES can be found under GREASES & PASTES MOTOR VEHICLES.)